Zmodem Parameters - Neoware c50 - Thin Client User Manual

File Transfer

ZMODEM Parameters

Clicking the ZModem... button in the Initiate File Transfer dialog box will cause
the ZModem Parameters dialog box to be displayed, as shown above. This enables
you to set parameters specific to the ZMODEM protocol.
The Outbound settings inform the remote end how to treat the data that will be sent
to it. The Inbound settings will override any Outbound settings specified at the
remote end.
The zmodemStartup resource or -zm command line option can be used to make
TeemTalk check incoming data for a remote ZMODEM startup sequence then
automatically start a file transfer using the settings specified in this dialog box. Note
that the transfer protocol selected in the Initiate File Transfer dialog box will be
ignored.
Data Conversion
Factory default: None
This specifies whether or not the file being transferred is converted to ASCII or
Binary format at the receiving end, or remains unchanged (None).
The Resume option enables you to send the remainder of a file if the transfer process
is interrupted, for example if data blocks were missed or the connection was lost.
This saves you having to retransmit the entire file again.
22-11