Configuring Client Version Checking - 3Com 5500-EI PWR Install Manual

Enable proxy
checking for a
port/specified
ports
Note:
The proxy checking function needs the cooperation of H3C's 802.1x client (iNode) program.
The proxy checking function depends on the online user handshaking function. To enable the
proxy detecting function, you need to enable the online user handshaking function first.
The configuration listed in the above table takes effect only when it is performed on CAMS as well
as on the switch. In addition, the client version checking function needs to be enabled on the switch
too (by using the dot1x version-check command).

Configuring Client Version Checking

Follow these steps to configure client version checking:
To do...
Enter system view
Enable
802.1x client
version
checking
Set the maximum number
of retires to send version
checking request packets
Set the client version
checking period timer
Note:
As for the dot1x version-user command, if you execute it in system view without specifying the
interface-list argument, the command applies to all ports. You can also execute this command in port
view. In this case, this command applies to the current port only and the interface-list argument is not
needed.
dot1x supp-proxy-check
In system
{ logoff | trap } [ interface
view
interface-list ]
interface interface-type
interface-number
In port view
dot1x supp-proxy-check
{ logoff | trap }
quit
Use the command...
system-view
In system dot1x version-check [ interface
view interface-list ]
interface interface-type
interface-number
In port
view dot1x version-check
quit
dot1x retry-version-max
max-retry-version-value
dot1x timer ver-period
ver-period-value
Required
By default, the 802.1x proxy
checking is disabled on a port.
—
Required
By default, 802.1x client version
checking is disabled on a port.
Optional
By default, the maximum number
of retires to send version checking
request packets is 3.
Optional
By default, the timer is set to 30
seconds.
1-17
Remarks