Configuring The Inner-To-Outer Tag Priority Replicating And Mapping Feature; Enabling Transparent Igmp Message Transmission On A Vlan-Vpn Port - 3Com 5500-EI PWR Install Manual
Hide thumbs
Also See for 5500-EI PWR:
- Reference manual (1314 pages) ,
- Getting started manual (118 pages) ,
- Quick reference manual (59 pages)
Table of Contents
Advertisement
Note:
Besides the default TPID 0x8100, you can configure only one TPID value on a Switch 5500-EI
switch.
For the Switch 5500-EI series to exchange packets with the public network device properly, you
should configure the TPID value used by the public network device on both the customer-side port
and the service provider-side port.
Configuring the Inner-to-Outer Tag Priority Replicating and Mapping Feature
Make sure that the VLAN-VPN feature is enabled on a port before configuring the inner-to-outer tag
priority replicating and mapping feature.
Follow these steps to configure the inner-to-outer tag priority replicating and mapping feature:
To do...
Enter system view
Enter Ethernet port view
Enable the inner-to-outer tag
priority replicating feature
Enable the inner-to-outer tag
priority mapping feature and
create a priority mapping
Caution:
If you have configured the port priority (refer to QoS-QoS Profile Configuration part in this manual),
you will be prompted that the port priority configured for the current port gets invalid after you
enable the inner-to-outer tag priority replicating feature.
The inner-to-outer tag priority replicating feature is mutually exclusive with the inner-to-outer tag
priority mapping feature.
Enabling Transparent IGMP Message Transmission on a VLAN-VPN Port
Follow these steps to enable transparent IGMP message transmission on a VLAN-VPN port:
To do...
Enter system view
Enter Ethernet port view
Use the command...
system-view
interface interface-type
interface-number
vlan-vpn inner-cos-trust
enable
vlan-vpn priority old-priority
remark new-priority
Use the command...
system-view
interface interface-type
interface-number
1-5
Remarks
—
—
Either of the two configurations
is required.
By default, neither the
inner-to-outer tag priority
replicating feature nor the
inner-to-outer tag priority
mapping feature is enabled.
Description
—
—
Advertisement
Chapters
Table of Contents
Troubleshooting
