Remote Switch App Upgrade Configuration Example - 3Com 5500-EI PWR Install Manual

Hide thumbs Also See for 5500-EI PWR:
Table of Contents

Advertisement

To do...
Display system diagnostic
information or save system
diagnostic information to a file with
the extension .diag into the Flash
memory
Display enabled debugging on a
specified switch or all switches in the
fabric
Display enabled debugging on all
switches in the fabric by modules

Remote Switch APP Upgrade Configuration Example

Network requirements
Telnet to the switch from a PC remotely and download applications from the FTP server to the Flash
memory of the switch. Update the switch software by using the device management commands through
CLI.
The switch acts as the FTP client, and the remote PC serves as both the configuration PC and the FTP
server.
Perform the following configuration on the FTP server.
Configure an FTP user, whose name is switch and password is hello. Authorize the user with the
read-write right on the directory Switch on the PC.
Make configuration so that the IP address of a VLAN interface on the switch is 1.1.1.1, the IP
address of the PC is 2.2.2.2, and the switch and the PC is reachable to each other.
The host software switch.app and the Boot ROM file boot.btm of the switch are stored in the directory
switch on the PC. Use FTP to download the switch.app and boot.btm files from the FTP server to the
switch.
Network diagram
Figure 4-1 Network diagram for FTP configuration
2.2.2.2
PC
Configuration procedure
1)
Configure the following FTP server–related parameters on the PC: an FTP user with the username
as switch and password as hello, who is authorized with the read-write right on the directory Switch
on the PC. The detailed configuration is omitted here.
2)
On the switch, configure a level 3 telnet user with the username as user and password as hello.
Authentication mode is by user name and password.
display diagnostic-information
display debugging { fabric | unit
unit-id } [ interface interface-type
interface-number ] [ module-name ]
display debugging fabric by-module
1.1.1.1
Network
Switch
Use the command...
4-6
Remarks

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500-ei series

Table of Contents