Advanced 802.1X Configuration; Configuring Proxy Checking - 3Com 5500-EI PWR Install Manual

Set 802.1x timers
Enable the quiet-period
timer
Note:
As for the dot1x max-user command, if you execute it in system view without specifying the
interface-list argument, the command applies to all ports. You can also use this command in port
view. In this case, this command applies to the current port only and the interface-list argument is
not needed.
As for the configuration of 802.1x timers, the default values are recommended.

Advanced 802.1x Configuration

Advanced 802.1x configurations, as listed below, are all optional.
Configuration concerning CAMS, including multiple network adapters detecting, proxy detecting,
and so on.
Client version checking configuration
DHCP–triggered authentication
Guest VLAN configuration
802.1x re-authentication configuration
Configuration of the 802.1x re-authentication timer
You need to configure basic 802.1x functions before configuring the above 802.1x features.

Configuring Proxy Checking

Follow these steps to configure proxy checking:
To do...
Enter system view
Enable proxy checking function
globally
dot1x timer
{ handshake-period
handshake-period-value |
quiet-period quiet-period-value |
server-timeout
server-timeout-value |
supp-timeout
supp-timeout-value | tx-period
tx-period-value | ver-period
ver-period-value }
dot1x quiet-period
Use the command...
system-view
dot1x supp-proxy-check
{ logoff | trap }
1-16
Optional
The settings of 802.1x timers are
as follows.
1) handshake-period-value:
15 seconds
2) quiet-period-value:
seconds
3) server-timeout-value:
seconds
4) supp-timeout-value:
seconds
5) tx-period-value: 30 seconds
6) ver-period-value:
seconds
Optional
By default, the quiet-period timer
is disabled.
Remarks
—
Required
By default, the 802.1x proxy
checking function is globally
disabled.
60
100
30
30