3Com 5500-EI PWR Install Manual page 870

Hide thumbs Also See for 5500-EI PWR:

Table of Contents

Network diagram

Figure 1-32 Switch acts as client and first-time authentication is not supported

Configuration procedure

Configure Switch B

# Create a VLAN interface on the switch and assign an IP address for it to serve as the destination of

<SwitchB> system-view

[SwitchB] interface vlan-interface 1

[SwitchB-Vlan-interface1] ip address 10.165.87.136 255.255.255.0

[SwitchB-Vlan-interface1] quit

Generating the RSA and DSA key pairs on the server is prerequisite to SSH login.

# Generate RSA and DSA key pairs.

[SwitchB] public-key local create rsa

[SwitchB] public-key local create dsa

# Set AAA authentication on user interfaces.

[SwitchB] user-interface vty 0 4

[SwitchB-ui-vty0-4] authentication-mode scheme

# Configure the user interfaces to support SSH.

[SwitchB-ui-vty0-4] protocol inbound ssh

# Set the user command privilege level to 3.

[SwitchB-ui-vty0-4] user privilege level 3

[SwitchB-ui-vty0-4] quit

# Specify the authentication type for user client001 as publickey.

[SwitchB] ssh user client001 authentication-type publickey

Chapters

Table of Contents

5500-ei series