3Com 5500-EI PWR Install Manual page 890

To do...
Download a remote file from
the FTP server
Upload a local file to the remote
FTP server
Rename a file on the remote
server
Log in with the specified user
name and password
Connect to a remote FTP
server
Terminate the current FTP
connection without exiting FTP
client view
Terminate the current FTP
connection and return to user
view
Display the online help about a
specified command concerning
FTP
Enable the verbose function
Specifying the source interface and source IP address for an FTP client
You can specify the source interface and source IP address for a switch acting as an FTP client, so that
it can connect to a remote FTP server.
Follow these steps to specify the source interface and source IP address for an FTP client:
To do...
Specify the source interface
used for the current connection
Specify the source IP address
used for the current connection
Enter system view
Specify an interface as the
source interface the FTP client
uses every time it connects to
an FTP server
Specify an IP address as the
source IP address the FTP
client uses every time it
connects to an FTP server
Display the source IP address
used by an FTP client every
time it connects to an FTP
server
Use the command...
get remotefile [ localfile ]
put localfile [ remotefile ]
rename remote-source
remote-dest
user username [ password ]
open { ip-address |
server-name } [ port ]
disconnect
close
quit
bye
remotehelp
[ protocol-command ]
verbose
Use the command...
ftp { cluster | remote-server }
source-interface
interface-type interface-number
ftp { cluster | remote-server }
source-ip ip-address
system-view
ftp source-interface
interface-type interface-number
ftp source-ip ip-address
display ftp source-ip
1-8
Remarks
Optional
Optional
Enabled by default.
Remarks
Optional
Optional
—
Use either command
Not specified by default
Available in any view