Configuring Line Rate; Configuring Traffic Redirecting - 3Com 5500-EI PWR Install Manual

Configuring Line Rate

Refer to section
Configuration prerequisites
The port on which line rate configuration is to be performed has been determined.
The target rate and the direction of rate limiting (inbound or outbound) have been
determined.
Configuration procedure
Follow these steps to configure line rate:
To do...
Enter system view
Enter Ethernet port view
Configure line rate
Configuration example
Configure line rate for outbound packets on Ethernet 1/0/1.
The rate limit is 1,024 Kbps
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] line-rate outbound 1024

Configuring Traffic Redirecting

Refer to section
Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The traffic redirecting destination has been determined.
The ports that need this configuration have been determined.
Line Rate for information about line rate.
Use the command...
system-view
interface interface-type
interface-number
line-rate { inbound |
outbound } target-rate
[ burst-bucket
burst-bucket-size ]
Traffic Redirecting for information about traffic redirecting.
1-22
Remarks
—
—
Required
Specify a committed
information rate (CIR) for the
target-rate argument, and
specify a committed bust size
(CBS) for the
burst-bucket-size argument.
By default, line rate is
disabled.