Troubleshooting - 3Com 5500-EI PWR Install Manual

Configuration procedure
Note:
Before enabling quick EAD deployment, make sure sure that:
The Web server is configured properly.
The default gateway of the PC is configured as the IP address of the Layer-3 virtual interface of the
VLAN to which the port that is directly connected with the PC belongs.
# Configure the URL for HTTP redirection.
<Sysname> system-view
[Sysname] dot1x url http://192.168.0.111
# Configure a free IP range.
[Sysname] dot1x free-ip 192.168.0.111 24
# Set the ACL timer to 10 minutes.
[Sysname] dot1x timer acl-timeout 10
# Enable dot1x globally.
[Sysname] dot1x
# Enable dot1x for Ethernet 1/0/1.
[Sysname] dot1x interface Ethernet 1/0/1

Troubleshooting

Symptom: A user cannot be redirected to the specified URL server, no matter what URL the user enters
in the IE address bar.
Solution:
If a user enters an IP address in a format other than the dotted decimal notation, the user may not
be redirected. This is related with the operating system used on the PC. In this case, the PC
considers the IP address string a name and tries to resolve the name. If the resolution fails, the PC
will access a specific website. Generally, this address is not in dotted decimal notation. As a result,
the PC cannot receive any ARP response and therefore cannot be redirected. To solve this
problem, the user needs to enter an IP address that is not in the free IP range in dotted decimal
notation.
If a user enters an address in the free IP range, the user cannot be redirected. This is because the
switch considers that the user wants to access a host in the free IP range, unconcerned about
whether this PC exists or not. To solve this problem, the user needs to enter an address not in the
free IP range.
Check that you have configured an IP address in the free IP range for the Web server and a correct
URL for redirection, and that the server provides Web services properly.
2-4