Ead Configuration Example - 3Com 5500-EI PWR Install Manual

Configuring the IP address of the security policy server.
Associating the ISP domain with the RADIUS scheme.
EAD is commonly used in RADIUS authentication environment.
This section mainly describes the configuration of security policy server IP address. For other related
configuration, refer to
Follow these steps to configure EAD:
To do...
Enter system view
Enter RADIUS scheme
view
Configure the RADIUS
server type to extended
Configure the IP address of
a security policy server

EAD Configuration Example

Network requirements
In Figure 3-2:
A user is connected to Ethernet 1/0/1 on the switch.
The user adopts 802.1x client supporting EAD extended function.
You are required to configure the switch to use RADIUS server for remote user authentication and
use security policy server for EAD control on users.
The following are the configuration tasks:
Connect the RADIUS authentication server 10.110.91.164 and the switch, and configure the switch
to use port number 1812 to communicate with the server.
Configure the authentication server type to extended.
Configure the encryption password for exchanging messages between the switch and RADIUS
server to expert.
Configure the IP address 10.110.91.166 of the security policy server.
AAA Overview.
Use the command...
system-view
radius scheme
radius-scheme-name
server-type extended
security-policy-server
ip-address
—
—
Required
Required
Each RADIUS scheme supports
up to eight IP addresses of
security policy servers.
3-2
Remarks