Remote-Ping Client Configuration - 3Com 5500-EI PWR Install Manual

Note that:
The remote-ping server function is needed only for jitter, TCP, and UDP tests.
You can configure multiple TCP/UDP listening services on one remote-ping server, with each
listening service corresponding to a specific destination IP address and port number.

remote-ping Client Configuration

remote-ping client configuration
After remote-ping client is enabled, you can create multiple test groups for different tests, without the
need to enable remote-ping client repeatedly for each test group.
Different types of remote-ping tests are somewhat different in parameters and parameter ranges. The
following text describes the configuration on remote-ping client for different test types.
Among the test types supported by remote-ping, only the ICMP test can be performed when XRN fabric
is enabled; all other test types cannot be performed when XRN fabric is enabled. With XRN fabric
enabled, you are allowed to configure remote-ping tests and use the display commands to check your
configurations, but for non ICMP tests, the remote-ping tests you configured cannot be executed until
fabric is disabled.
1) Configuring ICMP test on remote-ping client
Follow these steps to configure ICMP test on remote-ping client:
To do...
Enter system view
Enable the remote-ping client
function
Create a remote-ping test
group and enter its view
Configure the destination IP
address
Configure the source IP
address
Configure the test type
Use the command...
system-view
remote-ping-agent enable
remote-ping
administrator-name
operation-tag
destination-ip ip-address
source-ip ip-address
test-type icmp
1-5
Remarks
—
Required
By default, the remote-ping
client function is disabled.
Required
By default, no test group is
configured.
Required
By default, no destination
address is configured.
Optional
By default, no source IP
address is configured.
Optional
By default, the test type is
ICMP.