System Information Format - 3Com 5500-EI PWR Install Manual

Hide thumbs Also See for 5500-EI PWR:

Table of Contents

To sum up, the major task of the information center is to output the three types of information of the

modules onto the ten channels in terms of the eight severity levels and according to the user's settings,

and then redirect the system information from the ten channels to the six output destinations.

System Information Format

The format of system information varies with the output destinations.

If the output destination is console, monitor terminal, logbuffer, trapbuffer, or SNMP, the system

information is in the following format:

timestamp sysname module/level/digest: - unitid –content

The space, the forward slash /, and the colon are all required in the above format.

Before <timestamp> may have %, "#, or * followed with a space, indicating log, alarm, or debugging

information respectively.

Below is an example of the format of log information to be output to a monitor terminal:

6 10:44:55:283 2006 Sysname NTP/5/NTP_LOG:- 1 - NTP service enable

("-1-" indicates that the unit number of the device is 1.)

If the output destination is loghost, the switch and the log host use the syslog protocol. The system

information is in the following format according to RFC 3164 (The BSD Syslog Protocol):

<Int_16>timestamp sysname %%nnmodule/level/digest: source content

System MIB module

HWTACACS module

Telnet module

TFTP client module

Virtual local area network module

Virtual type terminal module

XModem module

Default settings for all the modules

Table of Contents

5500-ei series