Configuring Traffic Policing - 3Com 5500-EI PWR Install Manual

To do...
Enter Ethernet port view
Mark the priorities for
packets matching specific
ACL rules
Follow these steps to configure priority marking on a VLAN:
To do...
Enter system view
Mark the priorities for the
packets belonging to a
VLAN and matching
specific ACL rules
Configuration example
Ethernet 1/0/1 belongs to VLAN 2 and is connected to the 10.1.1.1/24 network
segment.
Mark the DSCP precedence as 56 for the packets from the 10.1.1.1/24 network
segment.
1) Method I
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-priority inbound ip-group 2000 dscp 56
2) Method II
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.0 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-priority vlan 2 inbound ip-group 2000 dscp 56

Configuring Traffic Policing

Refer to section
interface interface-type
interface-number
traffic-priority { inbound |
outbound } acl-rule { { dscp
dscp-value | ip-precedence
{ pre-value | from-cos } } | cos
{ pre-value | from-ipprec } |
local-precedence pre-value }*
system-view
traffic-priority vlan vlan-id
{ inbound | outbound } acl-rule
{ { dscp dscp-value |
ip-precedence { pre-value |
from-cos } } | cos { pre-value |
from-ipprec } |
local-precedence pre-value }*
Traffic Policing for information about traffic policing.
Use the command...
Use the command...
1-20
Remarks
—
Required
Refer to the
command manual
for information
about the acl-rule
argument.
Remarks
—
Required
Refer to the command
manual for information
about the acl-rule
argument.