3Com 5500-EI PWR Install Manual page 770

Configuring the enhanced cluster features
Complete the following tasks to configure the enhanced cluster feature:
Configuring cluster topology management function
Configuring cluster device blacklist
Configuring cluster topology management function
1) Configuration prerequisites
Before configuring the cluster topology management function, make sure that:
The basic cluster configuration is completed.
Devices in the cluster work normally.
2) Configuration procedure
Follow these steps to configure cluster topology management function on a management device:
To do...
Enter system view
Enter cluster view
Check the current topology and
save it as the standard
topology.
Save the standard topology to
the Flash memory of the
administrative device
Restore the standard topology
from the Flash memory of the
administrative device
Display the detailed information
about a single device
Display the topology of the
current cluster
Display the information about
the base topology of the cluster
Display the information about
all the devices in the base
cluster topology
If the management device of a cluster is a slave device in an XRN fabric, the standard topology
information is saved only to the local Flash of the master device in the XRN fabric.
Task
Use the command...
system-view
cluster
topology accept { all [ save-to local-flash ] |
mac-address mac-address | member-id
member-id | administrator }
topology save-to local-flash
topology restore-from local-flash
display ntdp single-device mac-address
mac-address
display cluster current-topology
[ mac-address mac-address1
[ to-mac-address mac-address2 ] |
member-id member-id1 [ to-member-id
member-id2 ] ]
display cluster base-topology
[ mac-address mac-address | member
member-id ]
display cluster base-members
1-17
Remarks
Required
Required
Remarks
—
—
Required
Required
Optional
Optional
These
commands can
be executed in
any view.