Configuring The Mapping Between 802.1P Priority And Local Precedence - 3Com 5500-EI PWR Install Manual

To do...
Enter Ethernet port view
Configure to trust port
priority and configure the
port priority
Follow these steps to configure to trust packet priority:
To do...
Enter system view
Enter Ethernet port view
Configure to trust packet
priority
Configuration example
Configure to trust port priority on Ethernet 1/0/1 and set the priority of Ethernet 1/0/1
to 7.
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] priority 7
Configure to trust packet priority on Ethernet 1/0/2.
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet1/0/2
[Sysname-Ethernet1/0/2] priority trust

Configuring the Mapping between 802.1p Priority and Local Precedence

When the default mapping between 802.1p priority and local precedence cannot satisfy
your requirements, you can modify the mapping at the CLI, thus modifying the mapping
between 802.1p priority and the output queues and assigning packets with different
priorities to the corresponding output queues.
Note that, this is a global setting, not a per port setting. This is only recommended for
advanced network environments.
Configuration prerequisites
The mapping between 802.1p priority and local precedence has been determined.
Use the command...
interface interface-type
interface-number
priority priority-level
Use the command...
system-view
interface interface-type
interface-number
priority trust
1-17
Remarks
—
Optional
By default, the switch trusts
port priority and the priority
of a port is 0.
Remarks
—
—
Required
By default, the switch trusts
port priority.