3Com 5500-EI PWR Install Manual page 226

Hide thumbs Also See for 5500-EI PWR:

Table of Contents

Configuring the Timeout Time Factor

Configuring the Maximum Transmitting

Rate on the Current Port

Configuring the Current Port as an Edge

Setting the Link Type of a Port to P2P

Enabling MSTP

Configuring an MST Region

Configuring How a Port Recognizes and

Sends MSTP Packets

Configuring the Timeout Time Factor

Configuring the Maximum Transmitting

Rate on the Current Port

Configuring the Current Port as an Edge

Configuring the Path Cost for a Port

Configuring Port Priority

Setting the Link Type of a Port to P2P

Performing mCheck Operation

Configuring Guard Functions

Configuring Digest Snooping

Configuring Rapid Transition

Configuring VLAN-VPN Tunnel

MSTP Maintenance Configuration

Enabling Trap Messages Conforming to 802.1d Standard

In a network containing switches with both GVRP and MSTP enabled, GVRP messages travel along

the CIST. If you want to advertise a VLAN through GVRP, be sure to map the VLAN to the CIST (MSTI

0) when configuring the VLAN-to-instance mapping table.

The default value is recommended.

To prevent network topology jitter

caused by other related configurations,

you are recommended to enable MSTP

after performing other configurations.

The default value is recommended.

Chapters

Table of Contents

5500-ei series