Configuring The Maximum Number Of Dynamic Arp Entries That A Vlan Interface Can Learn; Configuring Arp Source Mac Address Consistency Check; Arp Packet Filtering Based On Gateway's Address - 3Com 5500-EI PWR Install Manual

Configuring the Maximum Number of Dynamic ARP
Entries that a VLAN Interface Can Learn
Configuring ARP Source MAC Address Consistency
Check

ARP Packet Filtering Based on Gateway's Address

Configuring ARP Attack Detection
Configuring the ARP Packet Rate Limit Function
Configuring the Maximum Number of Dynamic ARP Entries that a VLAN Interface
Can Learn
Follow these steps to configure the maximum number of dynamic ARP entries that a VLAN interface
can learn:
To do...
Enter system view
Enter VLAN interface view
Configure the maximum
number of dynamic ARP
entries that the VLAN interface
can learn

Configuring ARP Source MAC Address Consistency Check

To do...
Enter system view
Enable ARP source MAC
address consistency check
ARP Packet Filtering Based on Gateway's Address
Follow these steps to configure ARP packet filtering based on gateway's IP address:
To do...
Enter system view
Task
Use the command...
system-view
interface vlan-interface
vlan-id
arp max-learning-num
number
Use the command...
system-view
arp anti-attack valid-check
enable
Use the command...
system-view
2-5
Remarks
Optional
The switch serves as a gateway.
Optional
The switch serves as a gateway or an
access device.
Optional
The switch serves as an access device.
Optional
The switch serves as a gateway or an
access device.
Optional
The switch serves as a gateway or an
access device.
Remarks
—
—
Optional
The value is 4031 by default.
Remarks
—
Required
Disabled by default.
Remarks
—