Configuring Member Devices - 3Com 5500-EI PWR Install Manual

To do...
Configure a shared FTP server
for the cluster
Configure a shared TFTP
server for the cluster
Configure a shared logging
host for the cluster
Configure a shared SNMP host
for the cluster
Configuring the network management interface for a cluster
1) Configuration prerequisites
The cluster switches are properly connected;
The shared servers are properly connected to the management switch.
2) Configuration procedure
Follow these steps to configure the network management interface for a cluster:
To do...
Enter system view
Enter cluster view
Configure the network
management (NM) interface for
the cluster

Configuring Member Devices

Member device configuration task list
Complete the following tasks to configure the member device:
Enabling NDP globally and on specific ports
Enabling NTDP globally and on a specific port
Enabling the cluster function
Accessing the shared FTP/TFTP server from a member device
Use the command...
ftp-server ip-address
tftp-server ip-address
logging-host ip-address
snmp-host ip-address
Use the command...
system-view
cluster
nm-interface Vlan-interface
vlan-id
Task
1-13
Remarks
Optional
By default, the management
device acts as the shared FTP
server.
Optional
By default, no shared TFTP
server is configured.
Optional
By default, no shared logging
host is configured.
Optional
By default, no shared SNMP
host is configured.
Remarks
—
Required
Required
By default, the management
VLAN interface is used as the
NM interface.
Remarks
Required
Required
Required
Optional