Network Management Interface Configuration Example - 3Com 5500-EI PWR Install Manual

# Connect the member device to the remote shared FTP server of the cluster.
<aaa_1.Sysname> ftp cluster
# Download the file named aaa.txt from the shared TFTP server of the cluster to the member device.
<aaa_1.Sysname> tftp cluster get aaa.txt
# Upload the file named bbb.txt from the member device to the shared TFTP server of the cluster.
<aaa_1.Sysname> tftp cluster put bbb.txt
After completing the above configuration, you can execute the cluster
{ member-number | mac-address H-H-H } command on the management device to switch to
member device view to maintain and manage a member device. After that, you can execute the
cluster switch-to administrator command to return to management device view.
In addition, you can execute the reboot member { member-number | mac-address H-H-H }
[ eraseflash ] command on the management device to reboot a member device. For detailed
information about these operations, refer to the preceding description in this chapter.
After the above configuration, you can receive logs and SNMP trap messages of all cluster
members on the NMS.

Network Management Interface Configuration Example

Network requirements
Configure VLAN-interface 2 as the network management interface of the switch;
Configure VLAN 3 as the management VLAN;
The IP address of the FTP server is 192.168.4.3;
Switch A operates as the management switch;
Switch B and Switch C are member switches.
Table 1-2 Connection information of the management switch
VLAN 3 (connected to Switch B)
VLAN 2 (connected to FTP server)
VLAN IP address
192.168.5.30/24
192.168.4.22/24
1-22
switch-to
Connection port
Ethernet 1/0/1
Ethernet 1/0/2