3Com 5500-EI PWR Install Manual page 851

Network diagram
Figure 1-14 Switch acts as server for password and RADIUS authentication
Configuration procedure
1) Configure the RADIUS server
This document takes CAMS Version 2.10 as an example to show the basic RADIUS server
configurations required.
# Add an access device.
Log in to the CAMS management platform and select System Management > System Configuration
from the navigation tree. In the System Configuration page, click Modify of the Access Device item,
and then click Add to enter the Add Access Device page and perform the following configurations:
Specify the IP address of the switch as 192.168.1.70.
Set both the shared keys for authentication and accounting packets to expert.
Select LAN Access Service as the service type.
Specify the ports for authentication and accounting as 1812 and 1813 respectively.
Select Extensible Protocol as the protocol type.
Select Standard as the RADIUS packet type.
1-31