Novell GROUPWISE 8 - INTEROPERABILITY Manual page 93

Add a delay so that the MTA is fully loaded before the WebAccess Agent starts to load:
load delay
delay 10
The length of the delay varies from system to system; ten seconds is a good starting place.
Transfer the WebAccess Agent
directory into the load script. Use Ctrl+C and Ctrl+V to copy and paste text
vol:\system
into the load script page.
load volume:\system\gwinter.nlm
/ph=volume:\domain\wpgate\webac80a
/user=username /PASSWORD=password
If you marked Yes under Load WebAccess Agent and Its MTA in Protected Memory?
(WebAccess Clustering Worksheet item
commands to specify the protected address space where the WebAccess Agent and
load
its MTA will run. Add a
load address space=addr_space_name
volume:\system\gwmta.nlm @domain.mta
load address space=addr_space_name
volume:\system\gwinter.nlm
/ph=volume:\domain\wpgate\webac80a
/user=username /password=password
protection restart addr_space_name
The result would look similar to the following example:
NOTE: The commands are needed only when the MTA and the WebAccess Agent are not
set
running in protected memory. The address space parameters are needed in the
only when the MTA and the WebAccess Agent are running in protected memory.
4 Click Apply to save the load script.
5 If necessary, click OK to confirm that you must offline and then online the volume resource in
order for the changes to take effect.
6 Continue with Modifying the Volume Resource Unload Script for the WebAccess
command from the
load
9), add the
command for the address space name.
protection restart
Implementing WebAccess in a NetWare Cluster
file located in the
strtweb.ncf
parameter to the
address space
load
commands
Agent.
93