Novell GROUPWISE 8 - INTEROPERABILITY Manual page 53

Setting the Failover Path and Policies for the Agents
To modify the failover path and policies for a GroupWise volume resource:
1 In ConsoleOne, in the properties pages for the Volume Resource object (volume_SERVER),
click Nodes to display the default failover path for the GroupWise volume resource.
2 Arrange the nodes in the cluster into the desired failover path for the domain or post office
volume (under Agent Clustering Worksheet items 3 or
3 Click Apply to save the failover path.
4 Click Policies to display the default start, failover, and failback policies.
The default policy settings are often appropriate. By default, a volume resource:
Fails over automatically if the node it is running on fails
Starts automatically on the next node in its failover path
Continues running at its failover location, even after its most preferred node is again
available
If you are considering changing these defaults, see the section about failover and failback
modes in the cluster documentation for your version of NetWare, as listed in
"Introduction to GroupWise 8 and Novell Cluster Services on NetWare," on page
5 Click OK when you are finished editing the GroupWise volume resource properties.
6 Skip to Section 3.6, "Testing Your Clustered GroupWise System," on page
6).
Setting Up a Domain and Post Office in a NetWare Cluster
Chapter 1,
19.
56.
53