Novell GROUPWISE 8 - INTEROPERABILITY Manual page 186

2 Mount the WebAccess Agent partition
the WebAccess Agent message queues are located.
3 From the software distribution directory, start the GroupWise Installation program and select
Configure GroupWise for Clustering.
4 Install the WebAccess Agent software, following the steps provided in
WebAccess
Guide.
5 Configure the WebAccess Agent according to the
Summary
Linux Cluster," on page
Server Information page.
As a result of selecting Configure GroupWise for Clustering on the preferred node, the
following cluster-specific configuration actions are performed:
The WebAccess Agent startup file (
groupwise/agents/share
same startup file regardless of which cluster node it is running on. The --home switch
includes the mount point and the path to the database so that the startup file is valid when
mounted to each cluster node.
If this is the first GroupWise agent installed on this cluster node, the GroupWise High
Availability service is automatically configured and its configuration file (
created in the
already been installed on this cluster node, the
WebAccess Agent.
186 GroupWise 8 Interoperability Guide
Agent" in "Installing GroupWise
Sheets" that you filled out in
181, paying special attention to the cluster resource information on the
on the shared resource so that the WebAccess Agent uses the
/etc/opt/novell/groupwise
(WebAccess Agent Clustering Worksheet item
WebAccess" in the
"GroupWise WebAccess Installation
Section 16.2, "Planning the WebAccess Agent in a
) is created in
webac80a.waa
directory. If another GroupWise agent has
gwha.conf
1) where
"Installing the Linux
GroupWise 8 Installation
mount_point/
gwha.conf
file is updated to include the
) is