Novell GROUPWISE 8 - INTEROPERABILITY Manual page 169

Because the agent startup files and log files are stored on the shared resource, they do not need
to be customized for each cluster node.
6 Configure the Internet Agent to run as a non-
of the GroupWise 8 Installation
"Running the Linux GroupWise Agents As a Non-root
"Setting Up Non-root Access on an NSS Volume on Novell Open Enterprise Server
Linux"
7 Repeat
Step 1 through
After you install and configure the Internet Agent on each node in its failover list, the cluster
node is ready for the Internet Agent to fail over to it.
8 Continue with Testing Your Internet Agent Installation on Each
Testing Your Internet Agent Installation on Each Node
1 Test the Internet Agent by starting it with a user interface, as described in
Internet Agent" in "Installing the GroupWise Internet
Guide.
/opt/novell/groupwise/agents/bin/gwia --show @gwia.cfg &
2 Stop the Internet Agent by clicking File > Exit.
3 After you can see that the Internet Agent stopped successfully, test it by starting it as a daemon,
as described in "Starting the Linux GroupWise Agents as
Agents" in the GroupWise 8 Installation
/etc/inet.d/grpwise start domain.gwia
/etc/inet.d/grpwise status domain.gwia
4 Stop the Internet Agent.
/etc/inet.d/grpwise stop domain.gwia
/etc/inet.d/grpwise status domain.gwia
5 Make sure you have completed all the tasks described in
Agent" in the GroupWise 8 Installation
A few tasks, such as assigning a postmaster, are not dealt with in this cluster-oriented section.
6 Repeat the steps in "Running the Internet Agent Installation Program on the Preferred Node"
on page 166 for each node in the Internet Agent failover list.
When you have installed the Internet Agent on all of the nodes in the Internet Agent failover list,
continue with Configuring the Clustered Internet Agent for
Configuring the Clustered Internet Agent for SSL
If you plan to enable SSL, as described in
"Internet Agent" in the GroupWise 8 Administration
and key file available to the Internet Agent in the cluster. The default locations for the SSL
certificate file and key file are on the cluster nodes along with the GroupWise software, rather than
root
Guide:
Step 6 for each cluster node in the Internet Agent failover list.
Guide.
Guide.
"Securing Internet Agent Connections with
user, as described in the applicable section
User"
Node.
Agent" in the GroupWise 8 Installation
Daemons" in "Installing GroupWise
"Installing the GroupWise Internet
SSL.
Guide, you must make the SSL certificate file
Implementing the Internet Agent in a Linux Cluster 169
"Linux: Starting the
SSL" in