Novell GROUPWISE 8 - INTEROPERABILITY Manual page 210

# define the mount point
MOUNT_POINT=/mnt/mount_point
sleep 8
ignore_error fuser -k $MOUNT_POINT
# del the IP address
ignore_error del_secondary_ipaddress $RESOURCE_IP
# umount the file system
exit_on_error umount $MOUNT_POINT
# return status
exit 0
Make the following changes to set up the unload script for the Monitor Agent.
3a Use the following command to stop the Monitor Agent:
/etc/init.d/grpwise-ma stop
3b On the
the load script.
3c On the
in the load script.
3d Adjust the
on your system without being inadvertently killed. by the
follows.
3e In the
to
The
4 Click OK to save the unload script.
Setting the Failover List and Policies for the Monitor Agent
1 On the Cluster Resource Properties page of the Monitor Agent cluster resource, click General.
The default policy settings are often appropriate. By default, a cluster resource:
Fails over automatically if the node it is running on fails
Starts automatically on the next node in its failover list
Continues running at its failover location, even after its most preferred node is again
available
If you are considering changing these defaults, see
Modes" in
Administration Guide for
2 Under Preferred Nodes, arrange the nodes in the cluster into the desired failover list for the
Monitor Agent
3 Click OK.
210 GroupWise 8 Interoperability Guide
RESOURCE_IP line,
line, change
MOUNT_POINT
command as needed so that the Monitor Agent can shut down normally
sleep
command (used if the Monitor Agent does not stop normally), change
fuser -k
.
-mk
parameter obtains the PID numbers of the processes to kill.
-m
"Installation and
Linux.
(Monitor Agent Clustering Worksheet item
change to the secondary IP address used in
172.16.5.18
/mnt/mount_point
"Setting Start, Failover, and Failback
Setup" in the OES Novell Cluster Services 1.8.2
to the mount point directory used
command that
fuser -k
4).
-k