Planning A Domain For The Webaccess Agent - Novell GROUPWISE 8 - INTEROPERABILITY Manual

Section 16.6, "WebAccess Agent Clustering Worksheet," on page 197
need as you set up the WebAccess Agent in a clustering environment. You should print the
worksheet and fill it out as you complete the tasks listed below:
Section 16.2.1, "Planning a Domain for the WebAccess Agent," on page 182
Section 16.2.2, "Selecting the WebAccess Agent Partition and Secondary IP Address," on
page 183
Section 16.2.3, "Determining an Appropriate Failover List for the WebAccess Agent," on
page 183
Section 16.2.4, "Determining Cluster Resource Information for the WebAccess Agent," on
page 183
Section 16.2.5, "Planning the MTA Installation," on page 184
Section 16.2.6, "Planning the WebAccess Agent Installation," on page 184
Section 16.2.7, "Planning the WebAccess Application Installation," on page 184

16.2.1 Planning a Domain for the WebAccess Agent

The considerations involved in planning a domain for the WebAccess Agent are much the same as
planning any other domain. In preparation, review
the "Domain
Keep in mind the following cluster-specific details:
When you specify the location for the domain directory on the Domain Worksheet, remember
that it is on a
Installation program. This location is referred to as the WebAccess Agent partition because it is
where the WebAccess Agent message queues are located.
Do not concern yourself with the GroupWise agent information on the Domain Worksheet.
You can stop with
When you have completed the Domain Worksheet, transfer the key information from the Domain
Worksheet to the WebAccess Agent Clustering Worksheet.
WEBACCESS AGENT CLUSTERING WORKSHEET
Under Item 1: GroupWise Partition for the WebAccess
WebAccess Agent Clustering Worksheet.
Under Item 2: WebAccess Agent Domain
the WebAccess Agent Clustering Worksheet.
IMPORTANT: Do not create the new domain until you are instructed to do so in
"Creating a Domain for the WebAccess Agent," on page
182 GroupWise 8 Interoperability Guide
Worksheet" in "Domains" in the
GroupWise partition, not on the node where you running the GroupWise
item 10. You will plan the MTA installation later.
"Planning a New
GroupWise 8 Administration
Agent, transfer the domain location to the
Name, transfer the domain name and database directory to
185.
lists the information you
Domain", then print and fill out
Guide.
Section 16.3.1,