Setting Up A New Groupwise System In A Cluster - Novell GROUPWISE 8 - INTEROPERABILITY Manual

When specifying the
each volume where a domain or post office resides. Use
cluster.
SLP
On NetWare 6.5, Novell Cluster Services automatically propagates virtual server information into
SLP and provides the most reliable name resolution.
3.2 Setting Up a New GroupWise System in a
Cluster
The GroupWise Installation Advisor walks you through setting up the primary domain and an initial
post office in the primary domain. You might be creating your primary domain and initial post office
on the same GroupWise volume or on two different volumes. After you have created the primary
domain and initial post office and installed the GroupWise agents, you can create additional
secondary domains and post offices as needed.
To set up the primary domain and initial post office for a new GroupWise system in a clustering
environment:
1 If necessary, map a drive to each GroupWise administration volume
Worksheet item
2 Map a drive to the GroupWise volume for the domain
and, if needed, to the GroupWise volume for the post office
item 8), where the primary domain and the initial post office for your new GroupWise system
will be created.
The GroupWise volume name will be cluster_volume. For assistance with mapping a drive to a
cluster-enabled volume, see
3 Manually create the domain directory
office directory
This step is not required, but in a clustered environment, the following step is easier if the
domain directory already exists.
4 Run the GroupWise Installation Advisor to set up your initial GroupWise system, following the
steps provided in
"Installing a Basic GroupWise
the following cluster-specific details:
When you specify the ConsoleOne directory and the software distribution directory, be
sure to browse to each location through the GroupWise volume accessed in
When you specify the domain directory and post office directory, be sure to browse
through the GroupWise volume accessed in
above.
For the post office link type, select TCP/IP Link.
When providing the MTA and POA network address information, use the Agent
Clustering Worksheet that you filled out in
Configure the Agents in a Cluster," on page
configure the MTA and POA objects in the domain and post office even though you have
not yet installed the agent software.
44 GroupWise 8 Interoperability Guide
commands you will need, use
map
6).
"Configuring Short Name Resolution" on page
(System Clustering Worksheet item
(System Clustering Worksheet item
"NetWare and Windows: Setting Up a Basic GroupWise
System" in the
System Clustering Worksheet item 7 or 8
System Clustering Worksheet item 3
(System Clustering
(System Clustering Worksheet item
(System Clustering Worksheet
12).
GroupWise 8 Installation
Step 2 to select the directory created in
Section 2.8, "Deciding How to Install and
28. The information you provide is used to
for
for
7)
42.
10) and the post
System" in
Guide. Keep in mind
Step 1 above.
Step 3