Novell GROUPWISE 8 - INTEROPERABILITY Manual page 151

# define the mount point
MOUNT_POINT=/mnt/mount_point
sleep 8
ignore_error fuser -k $MOUNT_POINT
# del the IP address
ignore_error del_secondary_ipaddress $RESOURCE_IP
# umount the file system
exit_on_error umount $MOUNT_POINT
# return status
exit 0
Make the following changes to set up the unload script for the agents.
3a Use the following command to stop the MTA:
/etc/init.d/grpwise stop domain
3b Use the following command to stop the POA:
/etc/init.d/grpwise stop post_office.domain
3c On the
RESOURCE_IP line,
the load script.
3d On the
MOUNT_POINT
in the load script.
3e Adjust the
sleep
system without being inadvertently killed by the
3f In the
fuser -k
The parameter obtains the PID numbers of the processes to kill.
-m
4 Click OK to save the unload script.
Setting the Failover List and Policies for the Agents
1 On the Cluster Resource Properties page of the GroupWise cluster resource, click General.
change
172.16.5.18
line, change
/mnt/mount_point
command as needed so that the agents can shut down normally on your
command (used if the agents do not stop normally), change
Setting Up a Domain and a Post Office in a Linux Cluster 151
to the secondary IP address used in
to the mount point directory used
command that follows.
fuser -k
to .
-k -mk