Setting Up New Instances Of The Agents Without Installing The Agent Software - Novell GROUPWISE 8 - INTEROPERABILITY Manual

The default policy settings are often appropriate. By default, a cluster resource:
Fails over automatically if the node it is running on fails
Starts automatically on the next node in its failover list
Continues running at its failover location, even after its most preferred node is again
available
If you are considering changing these defaults, see
Modes" in
Administration Guide for
2 Under Preferred Nodes, arrange the nodes in the cluster into the desired failover list for the
domain or post office (under
3 Click OK.
14.4.4 Setting Up New Instances of the Agents without
Installing the Agent Software
There are two steps to setting up new instances of the agents without installing the agent software:
"Creating New Startup Files" on page 152
"Modifying Existing Load and Unload Scripts" on page 153
Creating New Startup Files
Each MTA startup file is named after the domain it services, with a
startup file is named after the post office it services, with a
Configure GroupWise for Clustering option, the GroupWise Installation program creates agent
startup files in
152 GroupWise 8 Interoperability Guide
"Installation and Setup" in the
Linux.
Agent Clustering Worksheet items 3 or
mount_point/groupwise/agents/share
"Setting Start, Failover, and Failback
OES Novell Cluster Services 1.8.2
6).
extension. Each POA
.mta
extension. When you select the
.poa
on the shared resource.