11.2.1 Installing to Each Node in the Cluster
There are two methods of installing the Messenger agents to each node in the cluster:
Run the Messenger Installation program multiple times in order to install the agent software
and to create the agent startup files on each node in the cluster.
Run the Messenger Installation program, then copy the Messenger agent software and startup
files to each node in the cluster.
Use whichever method you prefer, following the steps provided in
Installation
Program" and
System" in the
Messenger 2.0 Installation
that the Messenger agents start successfully.
11.2.2 Installing to a Messenger Volume
Complete the following tasks to set up your Messenger system on a Messenger volume:
"Preparing the Cluster for Messenger" on page 117
"Running the Messenger Installation Program" on page 117
"Configuring the Messenger Volume Resource to Load and Unload the Messenger Agents" on
page 118
"Copying LDAP and QuickFinder Files to the Messenger Volume" on page 119
"Testing Your Clustered Messenger System" on page 119
Preparing the Cluster for Messenger
Cluster preparation for Messenger is the same as cluster preparation for GroupWise. Review
Section 3.1, "Preparing the Cluster for GroupWise," on page 41
installation program.
Running the Messenger Installation Program
The Messenger Installation program walks you through setting up your Messenger system and
installing the Messenger agents.
1 If necessary, map a drive to the Messenger administration volume
Worksheet item
7).
2 Map a drive to the Messenger volume
The Messenger volume name will be cluster_volume. For assistance with mapping a drive to a
cluster-enabled volume, see
"Creating Your Messenger
Guide. Make each node in the cluster active to make sure
(Messenger Clustering Worksheet item
"Configuring Short Name Resolution" on page
"Starting the Messenger
System" in
"Installing a Novell Messenger
before running the Messenger
(Messenger Clustering
Implementing Messenger in a NetWare Cluster 117
9).
42.
Need help?
Do you have a question about the GROUPWISE 8 - INTEROPERABILITY and is the answer not in the manual?
Questions and answers