Creating A New Secondary Domain In A Linux Cluster - Novell GROUPWISE 8 - INTEROPERABILITY Manual

IMPORTANT: Do not select the Configure GroupWise for Clustering option at this time.
6 When you set up the software distribution directory, install all the agent software.
Although this is not required when creating your initial domain and post office, it makes
installation of the other GroupWise agents easier after you have created the initial domain and
post office.
7 From the Installation program, run ConsoleOne to set up your initial GroupWise system, as
described in
Basic GroupWise
8 When providing the MTA and POA network address information, use the Agent Clustering
Worksheet that you filled out in
Linux Agents in a Cluster," on page
MTA and POA objects in the domain and post office even though you have not yet installed the
agent software on any nodes in the cluster.
Do not create users in the post office at this time.
9 When you have finished creating the primary domain and the initial post office, click Finish to
exit the GroupWise Installation program without installing the agent software.
10 Skip to
14.2 Creating a New Secondary Domain in a
Linux Cluster
After you have set up the primary domain and initial post office, as described in
"Setting Up a New GroupWise System in a Linux Cluster," on page
secondary domains in your GroupWise system as needed.
To create a new secondary domain in a clustering environment:
1 Mount the
2 In ConsoleOne, connect to the primary domain in your GroupWise system, as described in
"Connecting to a
3 Create the new domain, following the steps provided in
"Domains" in the
Use the Domain Worksheet you filled out in
Domain," on page 130
4 In the Link to Domain field, link the new domain to the primary domain of your GroupWise
system.
5 Use the Link Configuration tool to change the links from the new domain to all other domains
in the cluster to direct TCP/IP links, following the steps provided in
Protocol between Domains to
Administration
Although a complete mesh link configuration is the most efficient, it might not be feasible in all
situations. Set up as many direct TCP/IP links as possible for best MTA performance in the
cluster.
6 Make sure you are still connected to the primary domain.
138 GroupWise 8 Interoperability Guide
"Using ConsoleOne to Create Your Basic GroupWise
System" in the
Section 13.6, "Deciding How to Install and Configure the
"Running the GroupWise Installation Program on the Preferred Node" on page
GroupWise partition where the new secondary domain will be created.
Domain" in "Domains" in the
GroupWise 8 Administration
to fill in the fields in the Create GroupWise Domain dialog box.
TCP/IP" in
Guide.
GroupWise 8 Installation
132. The information you provide is used to configure the
GroupWise 8 Administration
"Creating the New
Guide.
Section 13.3, "Planning a New Clustered
"Message Transfer
System" in "Installing a
Guide.
Section 14.1,
137, you can create additional
Guide.
Domain" in
"Changing the Link
Agent" in the GroupWise 8
141.