Novell GROUPWISE 8 - INTEROPERABILITY Manual page 150

2 If this is an NSS volume or a shared pool, make the following changes:
2a In the service
GroupWise agent or agents that you want to run on this GroupWise partition.
If you created a domain on the partition, you need to stop the MTA. If you created a post
office on the partition, you need to stop the POA. If you created both a domain and a post
office, you need to stop both the MTA and the POA. Use the following commands as
needed for your GroupWise partition:
/etc/init.d/grpwise stop domain
/etc/init.d/grpwise stop post_office.domain
2b Adjust the
system without being inadvertently killed by the kill service command.
2c In the kill service command (used if the agents do not stop normally), change
The
2d In the kill service command, change
the load script.
2e In the
used in the load script.
2f In the
load script.
The result would be similar to the following:
3 If this is a traditional Linux volume, use the following unload script:
#!/bin/bash
. /opt/novell/ncs/lib/ncsfuncs
/etc/init.d/grpwise stop domain
/etc/init.d/grpwise stop post_office.domain
# define the IP address
RESOURCE_IP=172.16.5.18
150 GroupWise 8 Interoperability Guide
command, change
stop
command as needed so that the agents can shut down normally on your
sleep
parameter obtains the PID numbers of the processes to kill.
-m
del_secondary_ipaddress
command, change
umount
to the command to stop the
myservice stop
to the mount point directory used in
/mnt/generic
command, change a.b.c.d to the secondary IP address
to the mount point directory used in the
/mnt/generic
to .
-k -mk