Novell GROUPWISE 8 - INTEROPERABILITY Manual page 187

The
clusterimport.conf
directory from which you ran the GroupWise Installation program is updated, so that the
cluster-specific information collected when you configured the WebAccess Agent on the
preferred node is available when you install the WebAccess Agent on subsequent nodes.
The WebAccess Agent is not configured to start automatically on system startup. In a
cluster, you do not want the WebAccess Agent to start automatically whenever a node
restarts.
6 Continue with Running the WebAccess Agent Installation Program on Subsequent
Running the WebAccess Agent Installation Program on Subsequent Nodes
1 On the next node in the WebAccess Agent failover list, mount the WebAccess Agent partition
(WebAccess Agent Clustering Worksheet item
queues are located.
2 From the software distribution directory you created in
New GroupWise System in a Linux Cluster," on page
program and select Configure GroupWise for Clustering.
Because of the existence of the
software distribution directory, a new installation option, Import Clustering Data, is now
available on the main GroupWise Installation program page.
3 Install the WebAccess Agent software on the cluster node as usual, but do not use the
Configure option.
4 On the main page of the Installation program, click Import Clustering Data, then click Next.
file in the subdirectory of the software distribution
gwinst
1) where the WebAccess Agent message
Step 6
137, start the GroupWise Installation
file in the
clusterimport.conf
in Section 14.1, "Setting Up a
subdirectory of the
gwinst
Implementing WebAccess in a Linux Cluster 187
Nodes.