Creating A New Secondary Domain In A Cluster - Novell GROUPWISE 8 - INTEROPERABILITY Manual

Do not create users in the post office at this time.
In the Summary dialog box, the domain directory and post office directory that you
browsed to should display as UNC paths using the virtual server name with the
GroupWise volume.
5 When you have finished creating the primary domain and the initial post office, continue with
installing the GroupWise Agents, starting with
Configuring the MTA and the POA in a Cluster," on page
3.3 Creating a New Secondary Domain in a
Cluster
After you have set up the primary domain and initial post office, as described in
"Setting Up a New GroupWise System in a Cluster," on page
secondary domains as needed.
To create a new secondary domain in a clustering environment:
1 Map a drive to the GroupWise volume for the domain
where the new secondary domain will be created.
The GroupWise volume name will be cluster_volume. For assistance with mapping a drive to a
cluster-enabled volume, see
2 Manually create the domain directory
This step is not required, but in a clustered environment,
already exists.
3 If you selected
vol:\system
Agent Clustering Worksheet item
volume accessed in
or
If you selected
sys:\system
first.
4 In ConsoleOne, connect to the primary domain in your GroupWise system, as described in
"Connecting to a Domain" in "Domains" in the
"Configuring Short Name Resolution" on page
(System Clustering Worksheet item
on GroupWise volume as the agent installation location (under
1), create the
Step 1.
on each node, decide which node you will install the agents to
Setting Up a Domain and Post Office in a NetWare Cluster
Step 4 on page 49 in Section 3.5, "Installing and
48.
44, you can create additional
(System Clustering Worksheet item
Step 5 is easier if the domain directory
directory on the GroupWise
vol:\system
GroupWise 8 Administration
Section 3.2,
7)
42.
10).
Guide.
45