Table of Contents
Advertisement
Complete the following procedure to replace a disk mounted in the front of the chassis.
This CRU can be completed with the system powered on.
After replacing the disk, it takes approximately 2 hours for the disk rebuild process to complete.
NOTE:
This is an estimate, and the rebuild may take significantly longer depending on the amount of activity on the system.
Topics:
•
Identify a failed OS disk
•
Remove the front bezel to access front panel hard drives
•
Remove a hard drive
•
Install the hard drive
•
Install the front bezel
•
Verify the replacement drive
Identify a failed OS disk
Prerequisites
Establish a connection to the system as described in
page 14.
About this task
Complete the following steps to identify the failed OS drive.
Steps
1. Verify the drive fault LED on the left control panel at the front of the system is illuminated solid amber.
Replace an Operating System Disk
Establish a serial management connection to the PowerProtect system
Replace an Operating System Disk
2
on
17
Advertisement
Table of Contents
