Installing The Pa30 In An Applicator - Intermec PA30 User Manual

Chapter 1 — Learning About the PA30

Installing the PA30 in an Applicator

12
The following cables are optional depending on your installation:
• Standard DB9 serial cable to connect the PA30 to a host PC
• USB cable with "B" connector to connect the PA30 to a USB
device
• Standard Ethernet cable to connect the PA30 to your network
• 8-conductor cable with mini-DIN connector to connect
external error circuits such as sensors or switches
• 6-conductor cable with mini-DIN connector to connect an
external +5 or +24 VDC power supply
1 Place the PA30 in the mounting location on the applicator.
2 Install appropriate mounting hardware (max. size #8 or M4)
in the five mounting locations. Make sure the print engine is
securely mounted before proceeding.
3 Make sure the PA30 power switch is turned off.
PA30 Print Engine User's Manual