Intermec PA30 User Manual page 25

PA30 Print Engine User's Manual
4 (Optional) Connect the external power cable to the 6-pin
mini-DIN connector.
5 Connect the applicator port cable:
• For a Zebra-type applicator, connect the DB15 cable from
the PA30 Z-Style port to the applicator interface port on
the applicator.
• For a Sato-type applicator, connect the Centronics cable
from the PA30 S-Style port to the EXT port on the
applicator.
6 (Optional) Connect the Ethernet cable from the PA30
Ethernet port to your network.
7 (Optional) If you are using external error devices, connect the
external error cable from the PA30 External Error port to the
devices. For more information, see Chapter 2.
8 (Optional) Connect a standard serial cable from the PA30
serial port to a host PC.
9 (Optional) Connect a USB cable from the PA30 USB port to
a USB device.
10 Connect the power cable from the PA30 to an AC power
source.
The PA30 is now ready for media loading and configuration.
• For more information on loading media, see
Media" on page 15.
• For more information on configuring the PA30, see Chapter
3, "Configuring the PA30."
Chapter 1 — Learning About the PA30
"Loading
13