Intermec PA30 User Manual page 124

Chapter 7 — Managing, Maintaining, and Troubleshooting the PA30
112
2 No trap can be sent when this error/event occurs.
3 This error indicates that the PA30 has not received an IP
address. It is only applicable when IP SELECTION is set to
DHCP and/or BOOTP.
4 In the Direct Protocol, the user can enable error handling for
specific errors using the ERROR statement. When errors
added to the built-in error handling occur, this event will be
set. The text included in the SNMP trap is the standard text
corresponding to the error.
5 If an error occurs in the Fingerprint immediate mode (for
example, "out of paper" when the print key is pressed), this
event is set.
6 If an application is started but does not execute, the Ready-to-
Work indicator blinks. For example, this occurs if there is a
syntax error in the loaded program file.
This is useful when the PA30 has an AUTOEXEC.BAT file
(startup file) that is supposed to run automatically.
7 When execution is stopped with a user break (SHIFT +
PAUSE) or due to a run-time error, the Ready-to-Work
indicator turns off. The indicator is turned on if the user
either changes the mode to Direct Protocol or runs an
application.
If the application program handles the user break (ON
BREAK) or the run-time error (ON ERROR GOTO), the
Ready-to-Work indicator is not affected. In this case, it is up
to the application to set the status.
8 At most, but not all, PA30 crashes, the console is reset, which
turns off the Ready-to-Work indicator.
9 If the printhead temperature rises above 100°C (212°F), error
1088 occurs.
In Fingerprint, printing is cancelled. Resuming printing after
the printhead has cooled off to 85°C (185°F) must be handled
by the application program.
In Direct Protocol, the printing is paused and then
automatically resumed when the printhead has cooled off to
85°C (185°F). Meanwhile, the PA30 is able to receive
instructions and data until the buffer is filled.
PA30 Print Engine User's Manual