Chapter 4 — Configuring Print Engine and Media Settings
Direct Thermal Print Settings
74
• Set the Ribbon Constant to the value listed in the table and
decrease or increase it for lighter or darker images respectively
until you are satisfied with the printout quality.
General Thermal Transfer Print Settings
Media
Performance
Low (Europe)
Low (U.S.A.)
Medium (Europe)
Medium (U.S.A.)
High (Europe)
High (U.S.A.)
As a general rule, high energy and/or high print speed will
shorten the life of the printhead. Never use paper type and print
speed settings higher than necessary for obtaining acceptable
printout quality and throughput speed.
If the ambient temperature is lower than +15°C (+59°F), decrease
the print speed by 50 mm/sec.
When you select direct thermal printing, you also need to specify
these additional settings:
Label Constant
Choose a value appropriate to the type of media you are using.
For more information, see the next table.
Label Factor
Unless specified for your media, set to 40.
Adjusting Image Darkness
When adjusting the image darkness for non-Intermec direct
thermal media:
• Set the Label Factor to the recommended value for the type of
direct thermal media listed in the next table.
Ribbon
Ribbon
Constant
Factor
75
25
70
25
90
25
75
25
90
25
90
25
PA30 Print Engine User's Manual
Maximum
Print Speed
(ips)
150
150
200
200
225
225