Intermec PA30 User Manual page 39

PA30 Print Engine User's Manual
the pressure and lighten the print. You should print a few test
labels to check the quality after adjusting the pressure.
Or, you can locate the basic setting as follows:
a Turn the pressure adjustment knob counterclockwise until
there is no resistance. To test this, place a piece of media
under the printhead and pull it out. There should be little
or no resistance as you pull the media out.
b Turn the knob five full turns clockwise.
After you locate the basic setting, repeat the first part of Step 2
to determine the correct adjustment for your media.
Chapter 1 — Learning About the PA30
Printhead
pressure
adjustment
27