Display Messages - Intermec PA30 User Manual

Cause:
Result:
Error Number:

Display Messages

Message:
Cause:
Message:
Cause:
PA30 Print Engine User's Manual
Chapter 2 — Using the PA30 in an Applicator
Application sent a
PRINTFEED
port is enabled, the style is set to I-Style or Z-Style, and the
dataready signal is not enabled.
Terminates the printfeed command without printing a label.
1344
These messages appear in the PA30 display under certain
conditions when a
PRINTFEED
APPLICATOR PORT: Wait for signal.
Running a
PRINTFEED
startprint signal is received. The message appears when execution
has been blocked for a few seconds.
APPLICATOR PORT: Wait for reprint.
Running a
PRINTFEED -1,1
reprint signal is received. The message appears when execution
has been blocked for a few seconds.
in Fingerprint when the applicator
command is run.
command blocks execution until a
command blocks execution until a
47