Intermec PA30 User Manual page 33

PA30 Print Engine User's Manual
• 55 to 60 mm (2.16 to 2.3 in)
• 88 to 90 mm (3.5 in)
• 110 mm (4.3 in)
Snap the bobbin into the correct groove for the size of ribbon
you want to use. The bobbin should be centered in the ribbon
roll for best results. The wider the ribbon, the closer the
bobbin should be to the front of the PA30.
55-60 mm
(2.1-2.3 in)
88-90 mm
(3.5 in)
110 mm
(4.3 in)
Bobbin Placement: The bobbin should be in the center of the roll of ribbon.
Chapter 1 — Learning About the PA30
21