Adjusting The Print Mechanism - Intermec PA30 User Manual

Chapter 1 — Learning About the PA30

Adjusting the Print Mechanism

24
10 Turn the rewind hub to wind up the ribbon until all the
transparent leader is taken up. Keep the ribbon tight.
11 Turn the printhead lever to the Closed position.
12 Close the PA30 access door.
After you install media and ribbon, you may need to adjust the
PA30 print mechanism to get the best print quality.
• If you are using media less than the full size width, Intermec
recommends you adjust the printhead pressure arm. For help,
see the next section.
• If you are using thicker or thinner media than standard, you
can adjust the printhead pressure to darken or lighten the
print quality as needed. For help, see
Printhead Pressure" on page 26.
"Adjusting the
PA30 Print Engine User's Manual