Error Messages And The Ready-To-Work Indicator - Intermec PA30 User Manual

Chapter 7 — Managing, Maintaining, and Troubleshooting the PA30

Error Messages and the Ready-to-Work Indicator

Error Message and Ready-to-Work Indicator Descriptions
Error Message or Event Error No.
Print engine operational
Out of paper
Next label not found
Label not taken
Out of transfer ribbon
Transfer ribbon is installed 1058
(Print) Head lifted
Cutter does not repsond
Cutter error 1
Cutter error 2
Cutter error 3
Cutter open
110
• Applicator style should correspond to your applicator
system (Z-Style for Zebra-type, S-Style for Sato-type, I-
Style for Intermec-type).
For help, see "Configuring Applicator Port Settings" on
page 34.
• Make sure you have correctly connected the appropriate cable
from the PA30 Z-Style or S-Style port to the applicator. For
help, see "Installing the PA30" on page 9.
"Port Pinouts" on page 117.
diagrams, see
• Make sure all applicator cables and connectors are in good
working order.
This section lists PA30 error messages and describes the state of
the Intermec Ready-to-Work indicator on the PA30 front panel
for various operating conditions.
Note: The Ready-to-Work indicator status may also be affected
by your application settings.
Ready-to-Work
Indicator
- Steady
1005 Blinking
1031 Blinking
Blinking
1027 Blinking
Blinking
1022 Blinking
1059 Blinking
1701 Blinking
1702 Blinking
1703 Blinking
1704 Blinking
For pinout
Comments
No error
PA30 Print Engine User's Manual