External Power Port - Intermec PA30 User Manual

S-Style Port Pinouts (continued)
Pin Signal
7 Reprint
8 5V sensor
reference
9 Reserved
10 Ribbon low
11 Reserved
12 +24VDC
13 +5VDC
14 Power ground

External Power Port

External Power Port Pinouts
Pin Signal
1 +5VDC
2 Signal ground Input
3 +24VDC
4 Power ground Input
PA30 Print Engine User's Manual
Type Description
Input Enables Reprint mode via software. When this mode
is enabled, assert LOW to reprint last label. This
input is ignored when Reprint mode is disabled.
Input 5V sensor reference.
Output Goes HIGH when the amount of ribbon on the
unwind shaft is approximately 14 m (46 ft). Output
is LOW when the ribbon is completely out.
Output Power for external devices: +24VDC (±10%) @2A.
Power Voltage supply for external sensors. Configurable for
internal or external source.
Ground +24VDC return.
1
2
3
4
6
5
Type Description
Input +5VDC input for distribution through Applicator Port
connector (Z-Style pin 2, S-Style pin 13).
Signal return for +5VDC supply (Z-Style pin 1, S-Style pin 2).
Input +24VDC input for distribution through Applicator Port
connector (Z-Style pin 7, S-Style pin 12).
Power return for input (Z-style pin 8, S-style pin 2).
Chapter A — Specifications
121