Configuring The Pa30; Using The Web Browser Interface - Intermec PA30 User Manual

Chapter 1 — Learning About the PA30

Configuring the PA30

Using the Web Browser Interface

30
• Does the media have preprint areas that may be interfering
with LSS detection?
• Is there enough contrast between the black marks and the
surrounding areas?
• Does the liner have too little transparency?
• Does the LSS work with other types of media?
You can configure settings on the PA30:
• via the web browser interface. For more information, see the
next section.
• by placing the PA30 in Setup mode and using the printer
keypad and display. However, not all settings can be changed
in Setup mode. For more information, see Chapter 5, "Using
Setup Mode."
• by sending Fingerprint or Direct Protocol commands to the
PA30 via a serial connection from your desktop PC. For more
information, see the Intermec Fingerprint v8.xx Programmer's
Reference Manual.
After the PA30 has been assigned an IP address, you can manage
and configure it from any desktop PC on the network using a
web browser.
To connect to the PA30 using a web browser
1 On the desktop PC, open a web browser.
2 In the browser Address field, type the PA30 IP address and
press Enter. The PA30 main web page appears.
PA30 Print Engine User's Manual