Chapter 5 — Using Setup Mode
About Setup Mode
Placing the PA30 in Setup Mode
Navigating in Setup Mode
78
In Setup mode, you can use the PA30 keypad and display to view
and change configuration settings.
There are three ways to place the PA30 in Setup mode:
• Press Setup on the PA30 front panel.
• From the Intermec Shell program, press the left or right arrow
keys to choose SHELL SETUP and press Enter.
• Send the Fingerprint SETUP command from a host PC.
When the PA30 is in Setup mode, this text appears in the display:
When the PA30 is in Setup mode, you use the arrow keys to
navigate between menus and options.
Up arrow
Left arrow
Down arrow
• Press the right arrow key several times to cycle through the
settings menus. Press the left arrow key several times to cycle
through the menus in the opposite direction.
• Press the down arrow key to enter a settings menu and see the
first option for that setting. Press the right arrow key several
times to cycle through the options for that setting.
• To choose an option, press Enter.
• If the setting requires a value, press the left and right arrow
keys to select a digit in that value. Press the numeric keys
to enter values. When you finish setting the value, press
Enter. The next setting in that menu appears.
Right arrow
PA30 Print Engine User's Manual