Intermec PA30 User Manual page 130

Appendix A — Specifications
Z-Style Port Pinouts (continued)
Pin Signal
3 Start print
4 Feed
5 Pause
6 Reprint
7 +24VDC
8 Power ground
9 Ribbon low
10 Service required Output
118
Type Description
Input Pulse mode - prints one and only one label whenever this
pin is pulled to ground. Signal must be de-asserted and re-
asserted to print another label.
• Printing starts on HIGH to LOW transition if format
is ready.
• De-assert this signal to HIGH to inhibit printing.
Level mode - prints labels continuously when this pin is
pulled to ground. Printing is disabled when signal is de-
asserted. If a label is printing when de-asserted, printing
stops after that label is complete.
• Assert LOW to start printing if format is ready.
• De-asserted HIGH when current label has finished
printing. Remains de-asserted while waiting for next
label to be ready to print.
Input Assert LOW to feed label stock. De-assert HIGH to stop
feeding labels.
Input Assert this input LOW for 200ms, or until SERVICE
REQUIRED output pin changes state to toggle from
current pause state.
Input Enables Reprint mode via software. When this mode is
enabled, assert LOW to reprint last label. This input is
ignored when Reprint mode is disabled.
Output Power for external devices: +24VDC (±10%) @2A.
Ground +24VDC return
Output Goes HIGH when the amount of ribbon on the unwind
shaft is approximately 14 m (46 ft). Output will be LOW
when the ribbon is completely out.
Goes LOW during every status which keeps the printer
from printing:
• Media cover open
• Printhead open
• Ribbon out
• Media out
• General print engine fault
PA30 Print Engine User's Manual