Selecting A Facility - Intermec PA30 User Manual

Chapter 6 — Using the Intermec Shell Program

Selecting a Facility

90
• WINXP.PRG
Note: When an application starts, it may automatically change
the communication setup. If another application is selected later,
this communication setup remains valid, unless the new
application includes instructions that automatically change the
setup. The setup could also be changed manually in Setup mode.
Instead of running an application, you can choose from a
number of useful test and maintenance facilities:
Setup
Places the PA30 in Setup mode. For more information, see
Chapter 5, "Using Setup Mode."
Print Setup
Prints the current PA30 setup values (test label "Setup Info").
Testfeed
Feed out a number of label, ticket, tag, or portions of continuous
stock while the printer auto-adjusts its media feed and label stop/
black mark sensor. Intermec recommends that you perform a
testfeed each time you load a roll of labels from a new batch or a
different brand.
Test Label
Prints a series of four test labels (test labels "Diamonds", "Chess",
"Bar Codes #1", and Bar Codes #2") in order to test the printout
quality and printhead alignment. The labels are presented in an
infinite loop, so you can print the series over and over again. Press
Enter for each new label.
Default Setup
Resets all setup parameters to their default values. For a complete
list of defaults, see Appendix A.
Software Update
Using the Z-modem communication tool, files can be
downloaded from a PC, either to be stored on a standard
CompactFlash memory card or to upgrade the printer's firmware.
The following options are available:
• Update CompactFlash card allows the PA30 to be used as a
CompactFlash card programming device. Any files can be
PA30 Print Engine User's Manual