Installing The Cutter - Intermec EasyCoder PD41 Installation Instructions Manual
Cutter kit
Hide thumbs
Also See for EasyCoder PD41:
- Manual (163 pages) ,
- Service manual (110 pages) ,
- User manual (108 pages)
Table of Contents
Advertisement
Installing the Cutter
1 Unpack your cutter kit and check that all parts depicted below are included.
If not, contact your Intermec sales representative.
Cutter Mechanism
Cutter cover
2 Make sure the printer is turned off and disconnected from the power
supply. Remove the screw that holds the front cover. Remove the front
cover.
EasyCoder PD41/PD42 Cutter Kit Installation Instructions
Two screws
Cutter spring
Two cable clips
Two screws
(for plastic)
Advertisement
Table of Contents
Need help?
Do you have a question about the EasyCoder PD41 and is the answer not in the manual?